阳江附近想过夜电话联系

 Xinxiang Guosheng Machinery Equipment Co., Ltd
Guosheng machinery > News Center > technical knowledge >

How to operate ultrasonic vibrating screen on site

If you are looking for related products or have any other questions, you can call our sales hotline at any time, or click the button below to inquire about the quotation online!

National unified sales hotline: 0373-5419909
1. If the material has conductivity, please keep the power box away from the material site to prevent the material from entering the power box and causing short circuit.
2. Do not turn on the ultrasonic system when the mesh is not stretched, otherwise it is easy to cause power over-current and damage the transducer.
3. When the screening effect can be achieved, the power block should be adjusted as far as possible, and the maximum current should not exceed 0.4. Avoid unnecessary energy consumption and power over-current damage.
 Maintenance of ultrasonic vibrating screen
4. The best screening effect can be achieved only when the screen is tight, otherwise the ultrasonic output and vibration effect will be affected, and the screening effect and screening output will be seriously affected.
5. If you find that the noise in the power supply is too loud or the fan doesn't work, please stop working immediately and check the radiator fan. Please pay attention to ventilation when using the power box.
6. Each set of ultrasonic includes a resonant power supply, an oscillator and a network frame. Do not mix with other ultrasonic codes.
 Cleaning system of ultrasonic vibrating screen
7. The working power supply and voltage of the ultrasonic system are AC 220 v. the ultrasonic output power is led from the back panel of the power box and connected to the transducer, in which the red is the positive pole. Pay special attention to the voltage pole when connecting, and it is not allowed to connect wrongly.
8. The aviation plug screw on the transducer must be tightened, and the data wire should be regularly checked for damage. The aviation connector and data line must be wrapped with insulating tape to prevent dust. If the aviation plug is not tightened, it can not transport the vibration wave energy of the ultrasonic vibration screen, and the vibration effect will be lost.
9. The ultrasonic system needs to use the whole set of testing. Many customers have reported that the ultrasonic system can not be used normally after maintenance. The reason is that if the power box does not have any problems after the factory inspection, but the transducer is not checked, the transducer is broken. Only repair the power box and no problems can be found.
    Application site of ultrasonic vibrating screen


Xinxiang Guosheng Machinery Equipment Co., Ltd Yu ICP Bei 14028944-2 Address: west exit of Xinxiang Changji Expressway

Online consultation
Ask for a quotation
Sales Hotline

Sales Hotline: 13569819530